X-band 8.5-9.6GHz Transceiver Power Amplifier Module

This is an X-band 8.5–9.6 GHz pulse transceiver module. TX output power ≥40W, spurious ≤60 dBc. RX noise figure <4dB, image rejection ≥60 dBc. With high-isolation RF switch and digital IF attenuator, it provides full protection against overheat, overvoltage, overcurrent, VSWR and open antenna, ideal for radar and communication systems.

Product Detail

This is an X-band 8.5–9.6 GHz pulse transceiver module. TX supports 0.1–200μs pulse width, 20% duty cycle, ≥40W output power via N-type connector, pulse droop ≤0.5dB, spurious ≤60dBc. RX features noise figure <4dB, image rejection ≥60dBc, gain 20–60dB adjustable. Equipped with high-isolation RF switch and RS422 controlled attenuator, it provides full protection against overheat, overvoltage, overcurrent, VSWR and open antenna, suitable for radar, EW and broadband communication systems.

TX
frequency range	8.5-9.6 GHz
Input signal type	pulse
Input pulse width range	0.1 us~200us
duty cycle	20%
Input drive	-5~+5dBm
The output power of N-type connector	≥40 watts
Maximum pulse width of pulse droop	≤0.5 dB
spurious harmonic	≤60 dBc
Group delay variation in IF bandwidth	<15ns
protect	Protection must be implemented for maximum duty cycle and open antenna port conditions (VSWR=∞), with no time constraints.
	Backpressure, High Voltage, High Current, and Short Circuit Protection
	overheat protection
RX
Input RF frequency	8.5-9.6 GHz
noise factor	<4dB
maximum input power	10W
RF switch	SPST-60dB isolation <50nS establishment time
Enter P1dB	-10dBm (when the gain is 20dB)
LO to if leakage	-60dBc
acquire	20-60 decibels
intermediate frequency attenuator	31.5 dB 0.5 dB step (controlled by Rs422)
output P1dB	10±1 dBm
frequency gain flatness	±1 dB
spurious harmonic	≥70 dBc
spur	Input port load ≥100 dBc
image suppression	≥60 dBc